Designing a fit test for 3D printed parts
When two printed parts must fit, test their critical interface before making the full assembly. Make a small sample using the intended material and process, vary one dimension at a time, and record the result. There is no universal clearance that works for every printer, material and geometry.
Describe what “fits” means
A sliding lid, a press-in insert and a removable cover have different requirements. Write down whether the parts should move freely, stay located after assembly, or be removable without tools. Include the consequence of a poor fit: a loose sensor, a trapped cable or a cover that cannot be opened.
Measure the real mating component where possible. Label drawing values separately from values measured on a sample part.
Isolate the interface
A test piece can reproduce only the hole, slot, clip or mating surface that matters. Keep nearby geometry that could affect the interface, while leaving out unrelated decorative or bulky features. This reduces the cost of learning that a dimension needs to change.
Choose several candidate dimensions around your current design. The number and spacing of candidates depend on the mechanism and required fit; these should be agreed during design review rather than treated as a universal recipe.
Record the process as well as the dimension
Prusa’s design guidance notes that fit depends on factors including geometry, orientation, calibration, settings and material. A successful test is therefore evidence for the conditions you used, not a guarantee for every subsequent print.
| Record | Why it matters |
|---|---|
| Design revision and nominal dimensions | Identifies what was actually tested. |
| Material and machine/profile | Makes the trial interpretable and repeatable. |
| Orientation and preparation | Separates a design change from a process change. |
| Measured result | Records what the part actually did. |
| Assembly observation | Connects the measurement to the required function. |
Choose against an explicit criterion
An example criterion could be that a cover can be installed and removed repeatedly by hand while staying located during the planned demonstration. Define the number of trials and conditions before the test; those choices belong to the project, not to this generic guide.
Record the candidate you selected and any remaining uncertainty. Safety-critical and load-bearing applications require an appropriate engineering review beyond an informal fit check.
Sources and further reading
Try the prototype BOM budget calculator with CSV export or browse the fabrication planning tools.
Related equipment at DTU
Review the equipment page and confirm the setup and access process with staff.